Process Engineer Full Time

Major Areas of Responsibility

? Plan machining processes by studying work orders, blueprints, 3D models, wire frame models, engineering drawings, material specifications, reference planes, locations

of surfaces and machining parameters.

? Applies statistical methods and performs stack-up calculations to determine optimised manufacturing processes in terms of safety, quality, repeatability, and cost.

? Proactively resolves problems—technical, planning, or product quality—to maximize process repeatability, and minimize cost of production.

? Contributes and takes ownerships in the generation of PFMEA documents.

? Read and produce engineering drawings according to different international standards with a sound knowledge of GD&T

? Prepares/modifies technical drawings, specifications, calculations, visual aids and any other documentation for production instruction or fixture definition.

? Supports in the design and modification of tooling and fixtures.

? Delivers results on any business support project (i.e. cost saving, industrialization, NCR, Mods) on time and within budget.

? Prepare and maintain work Instructions to support production operators.

? Issues engineering official communication to production staff when an approved deviation is taken from work instructions.

? Works within the limits of authority as defined by the Manufacturing Engineering Procedures getting adequate approvals with deviations are required.

? Observes test cuts and FAIs during manufacturing processes

? Create or modify Process Flow Charts, covering all manufacturing process steps.

? Releases rework sequences in the ERP system, providing adequate instructions as required.

? Record and project manage all actions required to close any assigned engineering change proposal (ECP) successfully.

? Maintains an error-free configuration in the PLM and ERP systems for any assigned part numbers.

? Work independently with minimal supervision.

Education and Qualification

Bachelor degree in Aerospace, Automotive, Mechanical or Manufacturing Engineering

Aerospace, Defence and Oil &Gas is desirable.

PMP, Six Sigma or Lean Manufacturing certification preferred.

Experience

Minimum 5 years of relevant experience in the aerospace or automotive industries.

Demonstrated track record of implementing process improvement to enhance efficiency, eliminate waste and reduce costs.

Experience using CATIA V5 and/or Siemens NX.

Familiarity with non-conformance processes.